Fire Hydrant System
A fire hydrant is an active fire protection measure, and a source of water provided in most urban, suburban and rural areas with municipal water service to enable firefighters to tap into the municipal water supply to assist in extinguishing a fire. It works effectively in improving the fire fighting capacity of a place where it is installed. Apart from fire fighting purpose, these hydrated systems are also used in several other applications such as water transfer, irrigation etc.
Diesel Driven Fire Pump
Specifications
Portable Fire Pump
Portable Fire Pumps are an essential tool for professionally equipped fire and rescue services and departments, they are used to pump water from a water source for firefighting. A portable pump for fire fighting need to be rugged, tough, deliver pressure and flow while also being easy to use and handle.
Specifications
Pump Specifications:
- Aluminum body
- Bronze turbine
- Mechanical seal
- Stainless steel shaft
- Electric priming system, guaranteed up to 6m
- Two 2 1/2 ”(65 mm) outlets
- Suction: 4 ”(100 mm)
Engine Specifications:
- Volkswagen 46hp at 3600 RPM, air cooling.
- 4-cylinder, 4-T. Essence.
- Tank 11.4 l) separate.
Jockey Pump
A jockey pump is a small pump connected to a fire sprinkler system to maintain pressure in the sprinkler pipes. This is to ensure that if a fire-sprinkler is activated, there will be a pressure drop, which will be sensed by the fire pumps automatic controller, which will cause the fire pump to start.
Specifications
- Centrifugal mono block pump
- Pump body in cast iron and impeller in 304 Stainless Steel
- 3 phase electric motor with 1 hp to 40 hp / 220/440 V and 60 Hz
- Factory tested
- Versatility in performance and design
- Low operating cost
Motor Driven Fire Pump
Specifications
- Material: CI
- Frequency: 50/60Hz
- Voltage: 380V-440V
- Phase: Three Phase
- Power Source: Electric, Engine Driven